S o u n d P e r c u s s i o n L a b s . c o m
Hi-Hat Cymbal Stand Assembly
Close Up of Hi-Hat Clutch Assembly
1. Unfold hi-hat rod and hold upright.
2. Slide upper tube over the hi-hat rod and into leg
assembly. Tighten the wing nut at desired height.
3. Place one hi-hat cymbal onto the hi-hat rod with the
bottom side of the cymbal facing up.
4. Remove lower retaining nut and one rubber washer
from hi-hat clutch. Place the hi-hat clutch into the
top of the second hi-hat cymbal, and reassemble the
rubber washer and retaining nut under the cymbal. The
cymbal should rest between the two rubber washers.
5. Place the hi-hat clutch and cymbal assembly onto the
hi-hat rod. Tighten the wing nut on the hi-hat clutch
with the top cymbal approximately one to two inches
above the lower cymbal. Depressing the hi-hat pedal
will engage the two cymbals.
Hi-hat Rod
Upper Tube
Leg Assembly
Hi-hat Clutch
and Cymbal
Assembly
Washer
Lower Retaining Nut
Felt Washers
Upper
hi-hat cymbal
goes here
10183 SPL D2518 Kicker Pro Assembly Manual.indd 7
6/12/14 10:59 AM
