General Operating Instructions
AIR BAND SAW
1)
Air Supply
Compressor must be able to supply the saw with at least 1,00 m³/min (35 cfm)
clean and dry air at 7 bar (100 PSI).
Install a service unit, if necessary, but in any case use an oiler.
Minimum air hose diameter 13 mm (1/2“).
Blow air hose clear and connect it to the cleaned saw air inlet
(Check screen).
2)
Lubricator
Install service units or line oiler!
Check and if necessary fill with resin- and acid-free SAE 5 W to SAE 10 W
oil.
In winter or when using very moist air, use antifreeze lubricant, such as
“
Kilfrost
”, “
BP Energol AX 10
” or “
Kompranol N 74
”.
3)
Remember safety instructions and cutting hints!
ELECTRIC BAND SAW
1) Model 5 6047 0010 is designed for A.C. current only. Refer to the specification plate on your tool
to proper voltage and current rating.
CAUTION
: Do not operate your tool on a current on which the voltage is not within
correct limits. Do not oeprate tools rated A.C. on only D.C. current. To
do so may seriously damage the tool.
EXTENSION CORD SELECTION
If an extension cord is used, make sure the conductor size is large enough to prevent excessive voltage
drop which will cause loss of power and possible motor damage. A table of recommended extension
cord sizes will be found in this section. This table is based on limiting line voltage drop to 5 volts (10
volts for 230 volts) at 150% of rated amperes.
If an extension cord is to be used outdoors it must be marked with the suffix W-A or W following the
cord type designation. For example – SJTW-A to indicate it is acceptable for outdoor use.
RECOMMENDED EXTENSION CORD SIZES FOR USE WITH PORTABLE ELECTRIC BAND SAW
11
