H y d r a u l i c D r i l l
2 3 0 5 5 0 0 1 0
M a s c h i n e n f a b r i k G m b H
Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29
, www.spitznas.de
Translation of the original manual,
compiled: 14.02.11
230550010_en_Version_01
Page 5 of 16
Drilling
•
Install the tool at the machine.
•
Hydraulic lines. Attention: Pay attention to the correct order of the hoses.
First tank hose “T” (see switch diagram fig. 2).
•
Cool the drill with water
•
Actuate valve and start the drill-/ reaming up work.
After finishing the drill work
•
Release actuating lever (2)
•
Shut main valve (9), shortly press actuating lever (2), release rest pressure and
disconnect hoses. First pressure hose „P“ – fig. 3.
•
Take out drill tool.
•
Clean retainer seat
Maintenance
Keep the tool clean
•
Only regular maintenance ensures a constant capacity of the tool.
•
During the use of the hydraulic drill pay attention ot the following:
o
Cleanness of the oil.
o
Appropriate dirt protection of the lines and the connections of the drill.
o
Clean the drill after each job and protect it against corrosion with a light protection
oil.
o
At longer down time (a few days), rinse the drive with hydraulic oil.
Pressure Connection „P”
Tank Connection „T”
