CANOPY SERIES
PARKING GARAGE CANOPY SQUARE
I N S T A L L A T I O N M A N U A L
SURFACE MOUNT INSTALLATION W/J-BOX
(Caution: Before beginning installation turn off the circuit breaker and light switch)
SURFACE MOUNT INSTALLATION
(Caution: Before beginning installation turn off the circuit breaker and light switch)
www.spitzerlighting.com
702 Interchange Blvd., Newark, DE 19711
Specification is subject to change without notice
2/2
STEP 1
STEP 1
STEP 3
STEP 3
STEP 2
STEP 2
STEP 4
STEP 4
STEP 5
Loosen the screw on side
of the light, removing the
bracket from canopy light
by pulling it slightly out,
just leaving the ring on the
bracket.
Remove the lens and metal
plate by unscrewing the
screws.
Attach the canopy light
with the bracket by putting
the ring on clips again.
Connect the black wire
for line, white for neutral,
yellow and green for
ground.
Remove 1/2” plug from
direction you intend to
feed conduit.
Fix the bracket on J-box,
and put the wire through
the central hole for wiring
Cut off the wires through
from 3/4” hole and plug
the hole with provided
plug. Drill 4 holes on
edge of fixture and fix it
on the ceiling with using
appropriate screws.
Slide the canopy lights into
the bracket, and secure
the screw on side of the
light to prevent the light
from sliding out from the
bracket. Installation done.
Disconnect the wires came
3/4” hole and connect
the wires came from 1/2”
conduit with power supply.
(white for neutral, black for
line, yellow green/ green
for ground).
Replace the metal plate
and the lens, make sure
no wires are pinched when
replacing parts.
