Optional:
The (J) Left Hand of Limb Ripper has been made so it can hold a
severed limb (not included). Simply place a vinyl or latex severed
limb (sold separately) into his hand for an extra horrifying effect!
Note: Try adding newspaper or stuffing (not included) into the upper
arms of his shirt for added realism!
Operation Instructions:
1. Plug the UL power adapter into a standard power outlet and
adjust the settings on the Function Control box to your liking.
2. Limb Ripper has 3 operation settings which can be found on the
main Function Control box on the (F) Torso Frame:
-
On
: This setting allows the item to run continuously.
-
Sensor
: This setting allows the item to only be activated when the
light/motion sensor is activated. The item will operate for one
audio-cycle with each sensor activation.
-
Off/Try-Me
: This setting allows the item to be activated only if the
Try-Me is triggered.
3. The Function Control box also includes a Volume Control knob,
which allows you to adjust the volume to be as loud or as quiet as
needed. Be sure to test the item before finalizing your display so
you can set the volume to your liking.
Enjoy your Limb Ripper!
Step 4:
NOTE: The (H) Shirt opens in the front. Drape the (H) Shirt over the (F)
Shoulder Support & (E) Torso Frame and leave the front open for now. Set
the (I) Head onto the (E) Torso Frame by sliding the forked-hook into the
“neck” slot housing on the (E) Torso Frame. Next, connect the cables from
the (I) Head to the color-coordinated cables on the (E) Torso Frame. Now
fasten the hook and loop closure dots at the front of the (H) Shirt.
Step 5:
Slide the (J) Left Arm up through the left sleeve and slide the forked-hook into
the left “shoulder” slot housing on the (E) Torso Frame. Set the (K) Left Hand into
place by sliding the forked-hook into the “wrist” slot housing on the end of the
arm. Now, slide the (L) Right Arm up through the right sleeve and slide the
forked-hook into the right “shoulder” slot housing on the (E) Torso Frame. Set
the (M) Right Hand into place by sliding the forked-hook into the “wrist” slot
housing on the end of the arm.
PROP 65 WARNING:
Handling the coated electrical wires of this product exposes you to lead, a chemi-
cal known to the State of California to cause cancer, birth defects or other repro-
ductive harm. Wash hands after use.
Caution:
changes or modifications not expressly approved by the party respon-
sible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: Reorient
or relocate the receiving antenna. Increase the separation between the equipment
and receiver. Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. Consult the dealer or experienced radio/TV
technician for help.
H
I
F
F
