Spirent SmartBits System, Справочное руководство

Страница: 165 / 278

Chapter 11: ATM Cards
ATM ILMI Parameters
SmartBits System Reference 157
Line Event Statistics for the AT-9622 SmartCard
SmartWindow provides the following line event statistics for the AT-9622 SmartCard. To
access these statistics, select the Line tab on the
Statistics window :
•
Section BIP-8 . Section level Bit Interleaved Parity events counted since the last clear
counters event.
•
Line BIP-96 . Line level Bit Interleaved Parity events counted since the last clear
counters event.
•
Line FEBE . Line level Far End Block Error events counted since the last clear
counters event.
•
Path BIP-8 . Path level Bit Interleaved Parity events counted since the last clear
counters event.
•
Path FEBE . Path level Far End Block Error events counted since the last clear
counters event.
ATM ILMI Parameters
Applications
Supported:
SmartWindow, SmartLib.
Card Types:
All ATM Cards.
Methods:
Static Assignment or Dynamic Registration. The following definitions apply:
•
Cold Start Time . Enter the frequency that Cold Start traps are sent to the switching
device under test while attempting to register an ATM address until the process has
been successfully completed.
•
Register Timeout Timer . Enter the timeout value for failed address registration
retries.
•
End System Identifier (ESI) . Enter a 6-byte user-specific part of the 20-byte ATM
address using hex values. SmartCards that are connected to the same device under test
must have different ESIs. An easy way to assign the ESI is to map it to the slot number
that the ATM SmartCard resides. For example, if an ATM SmartCard resides on slot
#19, the ESI can be 00 00 00 00 00 19 or 00 00 00 00 00 13 (hexadecimal for 19).
(The latter is the default.)
•
Prefix . The 13-byte ATM network prefix.
•
Set . Selector byte-User defined 1-byte of portion of the 20-byte ATM address used by
the end station.
•
Status . The Status pane with the following fields is display-only, but may be copied: