spinflo OH88000NG PRODIGY 600, Руководство пользователя и инструкция по установке

Страница: 13 / 13

13
MAINTENANCE SERVICING
6. Spark Ignition (where fitted)
Remove the hob surface (2). Unscrew the 4 fixing screws and remove the generator
cover at the rear left of the appliance.
Hotplate burners - Pull off the fixing clip on the burner and remove electrode from the
burner cup. Trace the electrode wire back to the generator and pull off the connector.
Grill burner - Remove the push fit spark ignition wire from the probe in the top of the
burner. Trace the electrode wire back to the generator and pull off the connector.
Oven burner - Remove appliance from housing (3). Trace the electrode wire up the back
of the cooker to the generator and pull off the connector. Unscrew the fixing screw on the
spark electrode inside the oven cavity, then carefully pull the electrode from inside the
oven and remove.
Generator - Remove all electrode wires and pull off all power and earth wires. The
generator is a snap fit into the rear panel; using a flat head screwdriver, push in the 4 tabs
holding the generator in place and carefully remove from panel.
7. Hotplate burner injector (No62)
Lift off the panrest, remove the burner cap and spreader and unscrew the injector.
8. Grill burner injector (No62)
Remove the hob surface (2). To assist, the trim above the grill opening may be removed
by unscrewing the fixing screw on each side of the appliance. Unscrew the locknut on the
injector holder at the tube end of the burner, disengage the grill pipe from the control and
remove the injector.
9. Oven burner injector (No65)
Open the oven door and unscrew the burner retaining screw, slide the burner to the left
and lift out. The injector is exposed to the right hand side of the cut out. Unscrew the
injector.
10. Hob and grill thermocouples
Remove the hob surface (2). Unscrew the thermocouple from the control. Unscrew the
nut at the burner.
11. Oven thermocouple
Remove appliance from housing (3). At the right hand side of the appliance, remove the
side cover by unscrewing the fixing screws at front and rear, then unscrew the
thermocouple from the control. Inside the oven cavity, the thermocouple is found just
above the burner on the rear wall. Unscrew the locknut and pull out the thermocouple
from the rear of the appliance.
12. Removing doors
Grill door - Open the grill door halfway and remove the screw on top of the grill door
hinges. Carefully lower the grill door and remove. To remove the hinges, unscrew the 2
screws in the grill floor on either side at the front of the grill chamber.
Oven door - Open the door and remove the 2 screws retaining the top hinge, tilt the door
slightly forwards at the top and then lift the door off the bottom hinge.