spinflo Country Leisure KARINA 2020, Руководство пользователя и инструкция по установке

Страница: 3 / 9

MODELS KARINA 2020, KARINA 600, KARINA OVEN 8000, PRIMA II 9000
USER INSTRUCTIONS
INTRODUCTION
This appliance shall be installed in accordance with the local and national/European standards in
force. Particular attention shall be given to the requirements regarding ventilation. Read the
instructions before installing or using this appliance.
Failure to install the appliance correctly could invalidate any warranty or liability claims and lead
to prosecution.
PROVISION OF VENTILATION
The use of a gas cooking appliance results in a production of heat and moisture in a room in
which it is installed. Ensure that the kitchen is well ventilated: keep natural ventilation holes open
or install a mechanical ventilation device, (mechanical extractor hood).
Prolonged intensive use of the appliance may call for additional ventilation, for example opening
a window, or more effective ventilation, for example increasing the level of mechanical ventilation
where present.
The room containing the cooker should have an air supply in accordance with local and
national/European standards.
IMPORTANT
This appliance is suitable for use with Liquid Petroleum Gas (LPG)
and should not be used on
any other gas. The following gas pressures should be used:-
CAT I
3
+ (28-30/37) CAT I
3
B/P (30)
BUTANE (G30) 28-30 mbar BUTANE (G30) 30 mbar
PROPANE (G31) 37 mbar PROPANE (G31) 30 mbar
POSITION
This appliance must be positioned free from draughts, which may affect the combustion, and in a
manner that will prevent the accumulation of unburnt gas. When in use ensure that air vents are
not inadvertently blocked or shut off.
OPERATION
Ensure the gas cylinder or mains supply is turned on.
In the event of a gas smell turn off at the cylinder or mains supply and contact supplier.
HOTPLATE BURNERS
CAUTION: GLASS LIDS MAY SHATTER WHEN HEATED. TURN OFF ALL BURNERS AND
GRILL BEFORE SHUTTING THE LID.
Each burner is controlled individually and is monitored by a flame supervision device. In the
event of the burner flames being accidentally extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one minute. The respective knob positions are shown
in Fig.1.
Fig.1.
To light the burner, press in and turn the knob anti-clockwise to the full rate position and apply a
light to the burner or press the ignition button if fitted. It is necessary to hold the knob depressed
during ignition and for approximately fifteen seconds after the burner has lit to allow the probe to