INSTALLATION
The gas supply input pressure to which this appliance is connected, MUST not
rise or fall by more than 2.5 mbar (butane/propane) from nominal when ALL
appliances connected to the supply are OPERATED simultaneously.
If this appliance is not installed in accordance with the instructions and
tolerances detailed herein, we the manufacturer can not be held responsible for
any problems that occur, or poor performance that is perceived/witnessed.
In your own interest of safety, it is law that all gas appliances be installed by
competent persons. CORGI (Confederation for the Registration of Gas
Installers) registered installers undertake to work to safe and satisfactory
standards. Failure to install the appliance correctly could invalidate any warranty
or liability claims and lead to prosecution. This appliance shall be installed in
accordance with the local and national/European standards in force. Particular
attention shall be given to the requirements regarding ventilation. Read the
instructions before installing or using this appliance.
LOCATION OF APPLIANCE
This appliance maybe installed in a kitchen/kitchen diner but NOT in a room
containing a bath or a shower. LP gas appliances must not be fitted below
ground level. e.g. in a basement.
VENTILATION
This appliance must be installed according to the relevant local and
national/European standards in force.
This appliance is suitable for installation into Holiday Homes, Touring Caravans
and Boats. In all cases the national standards with regard to ventilation for the
particular vehicle into which the appliance is to be installed must be adhered to.
CONNECTION
An 8mm gas inlet point is provided on the underside of the appliance. It is
recommended that the unit be connected by copper tubing using an appropriate
connector.
Rubber tubing must NOT be used.
If the unit is fitted with spark ignition, care must be taken when the hob is sited
in position that none of the wires come into contact with the underside of the
hob or burner cups, as this could cause failure of the spark ignition to the hob.
After installation the appliance must be tested for soundness.
