SpinCore Technologies iSpin-NMR, Руководство пользователя

Страница: 19 / 30

iSpin-NMR
Conducting an NMR Experiment with the iSpin-NMR: Step-by-
step Instructions
1. Download and install the latest SpinAPI package available at:
http://spincore.com/support/spinapi/
The RadioProcessor Examples are part of the SpinAPI package.
2. Connect your iSpin-NMR system as shown in Figure 2 (page 7).
3. Check all connections and then power on your system. WARNING: A 50 Ohm load
MUST be presented to the “RF Power Out” connector of the iSpin-NMR system. If
no load/probe is connected, or if probe is not properly matched/tuned, you may
damage the system. For iSpin devices with SMA connectors that match Figure 5,
the “To Probe” connector corresponds to the “RF Power Out”. If you have any
questions, PLEASE contact us.
4. Create your own new working directory somewhere outside of the SpinCore directory
and copy the contents of the SpinAPI RadioProcessor Examples to your new working
directory. The SpinCore RadioProcessor directory can be found in the examples folder
located in the SpinAPI folder.
5. Edit the singlepulse_nmr_example.bat batch file by right-clicking and selecting “edit” and
save the batch file when finished. The timing values in the batch file correspond to
those in Figure 10, on the following page.
6. Run the singlepulse_nmr_example.bat file by double-clicking. Once the
singlepulse_nmr.bat file has completed, three new files (*.fid, *.jdx, *.txt) will be created
in the directory from which the batch file was executed.
2020-07-21 19 www.spincore.com