APPROX. MAX ALTITUDE: 50 m (160 ft)
T85601_0003_20115990_GEN_IS_R4
T85601_0002_20106417_GEN_IS_R4
CONTAINS 1 X 3.7V LIPO BATTERY PACK (INCLUDED).
Batteries or battery packs must be recycled or disposed of properly. When this product has
reached the end of its useful life, it should not be disposed of with other household waste. The
Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that
it can be treated using the best available recovery and recycling techniques. This will minimize the
impact on the environment and human health from soil and water contamination by any hazardous
substances, decrease the resources required to make new products and avoid using up landfill
space. Please do your part by keeping this product out of the municipal waste stream! The
“wheelie bin” symbol means that it should be collected as “waste electrical and electronic
equipment”. You can return an old product to your retailer when you buy a similar new one. For
other options, please contact your local council.
SPECIAL LiPo BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated
area. Keep away from flammable materials. - Do not expose to direct sunlight. There is a risk of the batteries
exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short circuit the batteries. Do not place
them in fires or leave them in hot places. - Do not drop or subject to strong impacts. - Do not allow the batteries
to get wet. - Only charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in
the device specified by Spin Master™. - Carefully read the instruction guide and use the batteries correctly. - In
the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. - Batteries must
be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed and non-replaceable.
Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or
deform product during disassembly. Ensure product is turned off, then use a screw driver to remove all screws.
Separate product body halves to expose internal electronics. When battery is visible in its entirety use scissors to
cut a single battery wire, immediately wrap the cut wire end with tape to isolate it, repeat until all battery wires are
cut and isolated, and the battery is free from the rest of the product. Dispose of battery in accordance with your
local battery recycling or disposal laws.
SPECIAL NOTE TO ADULTS: Regularly examine for damage to the plug, enclosure and other parts. In the event
of any damage, the toy must not be used with the charger until the damage has been repaired.
SPIN MASTER LTD. 225 KING STREET WEST, TORONTO, ON M5V 3M2 CANADA
Imported into EU by: SPIN MASTER INTERNATIONAL, B.V., Kingsfordweg 151, 1043 GR Amsterdam, The
Netherlands
www.spinmaster.com
Imported by Spin Master Australia Pty Ltd, Suite 101. Level 1, 18-24 Chandos Street,
St Leonards, NSW 2065;
1800 316 982
TM & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future
reference. Children should be supervised during play. Keep away from obstacles and electrical hazards. Spin
Master Ltd. reserves the right to discontinue the www.owleez.com website at any time. MADE IN CHINA
For TROUBLESHOOTING questions and solutions, please visit
our website: OWLEEZ.COM
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may
be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does
not resume, move the product to another location and try again. To ensure normal performance, change the
batteries, as low batteries may not allow full function.
a
WARNING: CHOKING HAZARD – Small parts. Not for children under 3 years.
e
NOTE: Under the environment with electrostatic discharge, the toy may malfunction and require user to
reset the toy.
e
CARE AND MAINTENANCE: Wipe the toy gently with a clean damp cloth. Keep the toy away from
direct heat. Do not submerge the toy in water. This can damage the electronic assemblies. This product is
intended for indoor use only. Do not use outdoors - dirt, grass, cement will scratch the finish and damage
the product. Do not play around water as this is a hazard and can cause a malfunction or damage the
electronic assemblies. Keep the toy away from direct sunlight and/or direct heat.
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.This equipment has been tested and found to comply with the
limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference to radio communications. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may
cause harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this toy does cause interference to radio or television reception (you can check
this by turning the toy off and on while listening for the interference), one or more of the following measures may
be useful:
• Reorient or relocate the receiving antenna
• Increase the separation between the toy and the radio or the TV
• Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any
transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15 and/or
95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the
equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221. To
contact the responsible party please visit fcc.spinmaster.com
Do not change or modify anything on the toy.
Keep hands, hair and loose clothing away from the rotors. Do not touch the rotating rotor.
Flying the toy requires skill and children must be trained under the direct supervision of an adult.
CAUTION: Do not start up or fly when persons, animals or any obstructions are within the flying range of the toy.
For safe use, the room where the toy is used must be sufficiently large.
This toy is intended to be used in domestic area (house) only.
WARNING:
Not suitable for children under 6 years of age.
BEFORE FIRST USE:
Read the user's information together with your child.
WARNING: ALWAYS OPERATE THE TOY AWAY FROM EYES OR FACE
2
HOW TO CHARGE
3. Owleez™ eyes will pulse
red when charging.
4. When fully charged
Owleez eyes will turn solid
green. Remove the charging
cable from the power source
after charging.
NOTE: before playing with Owleez make sure it is fully charged.
2. Turn your Owleez™ OFF
and place your Owleez™ in
the nest.
NOTE: Owleez CANNOT fly while charging or while the nest is plugged in.
NOTE: You can play with your Owleez™ while it is turned ON and in the nest, eyes will not blink to show charging.
1. Unravel and plug the USB
end of the charging cable
into a computer.
1
2
3
4
MEMORY RESET
If you want to reset my flying experience (so you can teach me to fly
from the start again):
Press and hold my BACK BUTTON for 10 seconds until my eyes turn
white and I make a long BEEP noise. After the beep, my memory will be
reset.
NOTE: Only connect USB charging cable to a computer.