77-2800-R-T - Instructions HONDA TALON Rear Vent Tinted Windshield - rev00
www.spikepowersports.com / 888-769-2295
1
INSTALLATION INSTRUCTIONS
HONDA TALON
REAR TINTED VENT WINDSHIELD
PART # 77-2800-R-T
IMPORTANT NOTICES
READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLATION TO
AVOID INJURY TO YOURSELF, DAMAGE TO THE VEHICLE OR ACCESSORY.
•
For proper installation, TWO people are required
.
•
Torque specifications must be followed when tightening bolts. Over-tightening any and/or all screws will cause
cracks around mounting holes which is not covered by any warranty.
•
As specified on carton label, once protective film on shields is removed, product cannot be returned.
•
As specified on carton label, damage caused by packaging staples is not covered by warranty. All staples must be
removed prior to removing product from carton.
•
Failure to follow these installation instructions completely may void any warrantable components and result in
product damage or personal injury.
•
Do not use Loctite or any other similar fastener adhesive. These types of products react to plastics and cause
cracking. Not covered by any warranty.
•
Our windshields are made from the highest quality material providing optimum transparency and clarity.
Blurriness and/or extrusion marks may or may not appear when looking through windshield from a wide, side-
angle. This is normal for all extruded clear plastic materials.
•
The application of improper cleaners, abrasive and/or dirty cleaning towels can severely damage the product.
Failure to follow cleaning recommendation (provided herewith) may void any warrantable components.
DEALER
These instructions contain important information for future reference and must be given to the customer at time of
purchase or upon completion of installation.
Parts List
(parts available with kit only and not available separately)
1. Installation
a)
Find a clean flat area where you can safely
lay down the windshield (Item A). Partially
remove the protective film on both sides and
apply the co-extruded bulb seal (Item C) to
the lower lip using manual pressure to
ensure good adhesion and cut any excess.
ITEM
PART NAME
DESCRIPTION
QTY
A
Windshield
CNC windshield cut-out made of ⅛" thick GE tinted polycarbonate or equivalent
1
B
Vent grill (#T5)
CNC vent grill cut-out made of
3
/
16
" tint polycarbonate
1
C
Co-extruded bulb seal (¼")
Includes: 63" Co-extruded bulb seal / #77-95BS
[end user to cut to exact length]
1
INSTRUCTION BAG
D
Flop clamp set
Includes: 4 flop clamps, 4 philips truss head screws M6 x 16 and 4 plastic shoulder washers M6
1
E
Vent hardware
Includes: 2 carriage bolts M6 x 30, 2 thin plastic washers, 4 plastic washers M6, 2 rubber washers
M6 and 2 female thread knobs M6
1
Co-extruded bulb seal
¼" (+/- 59 ¾")
