SpiderCloud Radio Node - SCRN-320 Hardware Installation Guide
22
Radio Node LED Management
The LED display is active by default, but can be deactivated in light-sensitive environments as needed.
Even when the display is disabled, the LED will be lighted during the following conditions:
•
while the radio node is booting
•
if the radio node or cell is in fault state
•
if there is an active emergency call
•
if the locate radio node feature is active
•
if the follow IMSI feature is active
shows the default LED behavior of the radio node:
* Refer to the
SpiderCloud OS (SCOS) Administrator Guide
for information about the locate radio node
and follow IMSI features.
4. Operating
System Booting
Flashing
Green
The radio node loads the operating
system and starts the default platform
applications.
The radio node moves to the next state
(State 5) when it establishes
connectivity with the service node.
Failure to start the operating
system.
This normally points to a
software/build issue. Please
contact SpiderCloud support.
5. Running
Solid
Green
The operating system is running. The
radio node continues the startup
sequence, but is now controlled by the
services node.
The operating system is up and
running on the radio node.
Any subsequent state
transitions can now be tracked
from events and logs on the
services node.
Table 7: Radio Node LED Behavior
LED
Status
Flash Rate
Green: slow flashing Administratively disabled
Approximately ½ second on, 1½ sec. off
Green: fast flashing Booting
Approximately 1.4 second on/off cycle
Green: solid
Operational
Red: solid
Fault
Red: fast flashing
One or more emergency calls active
Approximately 1 second on/off cycle
Blue: fast flashing
Locate radio node enabled*
Approximately 1 second on/off cycle
Blue: solid
Follow IMSI enabled*
Off
Powered off or LED disabled
Table 6: Radio Node LED Boot Sequence
(continued)
State
LED Color
Description
Possible Failures and Actions
DRAFT
SpiderCloud Wireless, Inc. Proprietary and Confidential