Reeving
• Push the primary suspension wire rope through the the wire
rope inlet of the overspeed safety lock and guide it into the
wire rope inlet of the hoist’s traction compartment
15
.
• When you cannot push the wire rope into the hoist’s traction
compartment any further (because the traction roller has
gripped it), operate the hoist in the
UP direction until the
wire rope passes through the hoist’s traction compartment
exit
.
• If the hoist is equipped with an optional secondary suspension
wire rope, push the secondary suspension wire rope through
the wire rope inlet in the inclination safety lock
11
until it
passes through the ISL exit
13
and the brackets.
• Attach a 25-lb (11.5-kg) weight to the end of the secondary
wire rope to assist secondary wire rope travel.
Hoist Operation Quick Reference
UpPro Series Hoists
READ THE OPERATOR’S MANUAL BEFORE USING THIS QUICK REFERENCE
UP Operation Button
Emergency Stop
(Power
Supply Cut-off)
GREEN
Power Indicator Light
Primary Wire Rope Inlet
DOWN Operation Button
Operating Instructions
Manual and Schematic
Carrying Handle
Power Supply Cable
Primary Suspension
Wire Rope Exit
14
Normal Operation
• Switch the control unit on by turing the red emergency stop button on the pendant in the clockwise direction until it pops out.
• For routine travel in the
UP direction, push in the
UP operation button
. For routine travel in the
DOWN direction,
push in the
DOWN operation button
.
• The
UP/
DOWN buttons have two pressure points. The fi rst pressure point is for the slower speed. Push the
UP or
DOWN button again for the faster speed. On 4-speed models, press the yellow
yellow
button
for the next highest speed.
• The
UP/
DOWN buttons are spring-loaded and will return to the OFF position AND apply the brake when released.
• If the hoist does not immediately stop the platform, press the emergency stop
AND turn the overspeed brake
ACTIVATION lever
12
in the LOCK direction
. Unplug the power supply cable
.
• Perform daily testing and inspection (see over) to ensure safe and correct operation. Do NOT use the hoist for
lifting until it has successfully completed the daily tests.
•
WARNING!
Do NOT operate the hoist if, at any time, you cannot see the fl ywheel turning.
Platform Mounting
Stirrup Bar
Primary Suspension
Wire Rope Inlet
Inlet for Optional
Secondary
Suspension Wire
Rope
Inlet for Optional
Secondary Wire Rope
721022-1/A
RED
Overload Trip Indicator Light
Brake Release Lever
(Storage Position)
Hand Wheel
(Storage Position)
Hour Meter
Optional Secondary Wire Rope
Exit for Optional Secondary
Wire Rope
13
Optional Inclination Safety Lock
(ISL)
11
Overspeed Brake ACTIVATION
Lever
12
Overspeed Brake RESET Lever
17
Overspeed Safety Lock (OSL)
16
Electrical Box
Traction Compartment
Pendant
Flywheel Observation Window
25-lb Weight for Optional
Secondary Wire Rope
Motor Brake Release Lever
(Operating Position)
Hand Wheel
(Operating Position)
Primary Wire Rope Inlet in
Traction Compartment
15
YELLOW
YELLOW
2-Speed Button/ Low Voltage
Indicator (3-Phase Models only)
