Spida Wall Extruder, Руководство по эксплуатации и техническому обслуживанию

Страница: 29 / 75

28 Operations Manual
– Wall Extruder (Frame Nailer Gen IV and Tables)
in place, the clamps will bottom out, and the sensors will not activate. If the stud is not being
clamped correctly, and/or the clamps do not line up correctly, the sensors will not activate.
- The last type of sensor is located on the side of the Vertical Plate Clamp, one on each carriage,
and confirms that the plate has been loaded and clamped correctly. If there is no plate in place,
the clamps will bottom out, and the sensors will not activate. If the plate is not being clamped
correctly, and/or the clamps do not line up correctly, the sensors will not activate.
Ensure that all three types of sensors are activated, before progressing to the next step.
If any problems occur during clamping, or if the set-up is incorrect, simply press the reset button
shown in Figure 2 to release the clamps and begin clamping again.
Note: If the sensors do not activate (for any of the above reasons), or there is another error of some
sort, the Wall Extruder will not fire and will send and error to the program. The detail of the error
will then be shown on the bottom of the computer display screen.
Once the clamps have been applied and everything is sitting square, the firing sequence can begin.
This is initiated by simultaneously holding both
RED firing buttons (shown in Figure 2) down, until
the guns have finished firing; nailing the frame as required.
If at any time during the clamping or firing sequences either of the
RED firing buttons are released
prematurely, the sequence will stop, and air pressure will be expelled from the exhaust. When both
buttons are depressed again, the sequence will reset, and the operation will commence.
Note: It is the responsibility of the operator to ensure the firing area is clear of obstructions that may hinder
safe firing operation! This includes but is not limited to other personnel working in the immediate area!
Never attempt to fire Nail Guns if the timber is not correctly in place or if there is no timber in the machine.
Always keep hands clear of Clamping
Once the firing sequence is complete, and the firing buttons have been released, the clamps
automatically release, the stud pins drop, and the progressors advance the frame to the next stud
position where the above sequence starts again.
Once a frame is complete, set up the next set of plates as required, then follow the above sequence
again until the next frame is complete.
9.9 Air Dump
In an emergency, or when disconnecting the air supply or performing any maintenance, the air must
be dumped from the system. Dump any air in the system using the dump valve (see Figure 5, item
D).
9.10 Machine Shut-down
Once operations are complete, ensure that the Wall Extruder is switched off and any foreign
tools/equipment are removed.