20
19
Q & A
After installation, why does air leakage occur?
Tire valves may not be of universal standard. Check with your installer.
There are two methods:
1. External sensors can be taken off and screwed onto the correct position;
or
2. Users can utilize the Tire Swap function to exchange two tire
positions each time, until all tires are swapped to the correct position.
Do I need to perform a dynamic wheel balancing?
After installing internal sensors, dynamic wheel balancing is a must.
Dynamic balancing is not required for external sensors.
During a wheel rotation, how can I make sure the sensors are in the right position?
Q
A
Q
A
Q
A
What happens if I separate my trailer and my 4-wheel vehicle? Will the
display alarm and report sensor failure?
If the display fails to receive all of the pre-paired tyre signals from the
trailer at the same time, it will pause the status of trailer data. The display
will not alarm and report for sensor failure.
Q
A
Where do I find help?
The first point of contact should be your direct seller. For more help, visit
our website www.
coastrv.com.au
.
Q
A
What to do if I want to upgrade to ten tires?
Please purchase extra sensors from authorised stores and follow the
sensor pairing instructions in this manual to pair the extra sensors to your
display. It is easy.
Q
A
What happens if I lost a sensor?
Please purchase a new sensor from a distributor.
Q
A
1. Ensure that all the sensors are present, and the display is fully
charged and turned on;
2. Ensure there are no electronic interference around;
3. Drive the vehicle over 20km/h for 5 minutes;
4. Ensure that the sensor battery is working and then repeat step 3.
[Note: The display has low sensor battery warning to alert the user. If it
is a new unit, skip to step 4.]
5. If data is still missing, commence sensor pairing.
Q
A
The display is missing data, what should I do?
You can press any button to temporarily silence the display, or turn off
the display.
Q
A
How to silence the display alarm?
