FR
16
EN
the character
1
to flash.
c) Now press the
button to display 1, i.e., switching on the laser func-
tion.
d) Or press the
button to display 0 with the symbol on the LCD screen
disappearing, i.E., switching off the laser funcion.
e) After the selection, press the SET button to save the setting parameters
7. Exiting the setting mode
a) When setting the function parameters, continuously press the
SET
but-
ton to exit the setting function.
b) When no button is pressed (no operation) for 12 seconds, it will exit the
setting function automatically.
8. Changing the batteries
Display: when the battery symbol
flashes on the LCD screen, it indicates
the batteries are low.
Operation: open the battery cover and change the old batteries with two new
AA alkaline batteries.
Chapter 9- Storage and transportation
The non contact infrared TempO Laser shall be stored in a well-ventilated
room free of corrosive gases, with a temperature of -25~55°C and a relative
humidity of not higher than 90%. Sling , stress, drench or trample on the
package shall be avoided during transportation and loading/unloading.
Besides, it shall be placed according to the marked direction on the packaging.
Chapter 10- Products troubleshooting
Symptom
of machine failure
Measured temperature
lower or higher
Solution
1. View whether the func-
tion key “F4” has been
changed, the factory de-
fault value is 0.0.
2. The machine can auto-
matically compensate for
ambient temperature
variations, but if the
ambient temperature
changes too much or test
in a high-temperature
environments then
quickly transfer to a low-
temperature environ-
ments, the equipment
required to be kept in a
stable environment for 10
~ 30 minutes for the next
Other method
1. To the designated
maintenance
depart-
ment for repair
2. Return to distributors,
dealers, then transfer to
the factory for repair or
replace.
Notice Temp'O Laser_Notice Temp'O Laser 09/11/10 15:28 Page16
