EN
6
4. Remove the bind plug from the BIND/PROG port on the receiver before you
power off the transmitter and store it in a convenient place.
NOTICE
: Remove the bind plug to prevent the system from entering bind mode
the next time the power is turned on.
5. After you set up your model, always rebind the transmitter and receiver to
set the desired failsafe positions.
Using the AR6335 Receiver With AS3X
By default, AS3X technology is turned off in AR6335 receivers. Before activating AS3X,
you will need to properly install the receiver in the aircraft and download the Spektrum
AS3X Programmer application to your mobile device. An interface cable (SPMA3081
sold separately) is required for programming the receiver.
Activating AS3X
1. Bind the transmitter and receiver.
2. Download the Spektrum Programmer from SpektrumRC.com or from your
mobile device (iOS or Android).
3. Power on the transmitter and receiver.
4. Open the Spektrum AS3X Programmer.
5. Connect the audio interface cable to the BIND/PROG port of the receiver and
the device.
6. Use the application to program the receiver. For instructions on how to use
the application, please consult the manual in the application.
7. Press “Update” in the application to save the receiver programming.
Installing the Receiver
1. You can install the receiver under the canopy or in the bottom of the
fuselage. The servo pins must point toward the nose or tail of the fuselage.
2. Connect the servo leads to the receiver.
3. Use double-sided foam tape to secure the receiver.
Important: Y-Harnesses and Servo Extensions
When using a Y-harness or servo extensions in your installation, it’s important
to use standard, non-amplified Y-harnesses and servo extensions. Amplified
Y-harnesses and servo extensions will cause the servos to operate erratically or
not function at all.
Setting the Failsafe Positions
The Receiver features two types of failsafe: SmartSafe and Preset Failsafe.
SmartSafe
SmartSafe
™
failsafe is recommended for most aircraft.
