ELECTRICAL INSTALLATION FOR
SPEEDY-LIFT
1.
Thread the lead power cable (red +) under the doorstep molding and through the
firewall.
WARNING
: Pass through a grommet in the firewall to prevent the cable from
chaffing.
2.
Install the circuit breaker near the battery and then connect the battery to the circuit
breaker.
3.
Attach the ground wire (black -
) to the vehicle’s frame, under the doorstep mo
lding
using a self-tapping screw.
NOTE
: It is preferable to locate it in a spot where the sheet
metal is doubled-up to insure a better ground.
4.
Thread the hand held control wire under the doorstep molding and up under the
dash. Secure the wire in place under the dash with a tie wrap and secure the hand
held control on the dash using “Velcro”.
WARNING
: Place the hand held control in a
safe place so that the door does not risk cutting off the wire.