OPERATION OF THE LOG SPLITTER
OPERATOR
ZONE
TONGUE
FOOT PLATE
ENGINE
ONLY
operate the log splitter from the operator zone as
shown in the diagram. The operator has the safest and
most efficient access to the control valve and the beam
in this location. Failure to operate the log splitter in this
position can result in serious injury or death.
Page 3
BEAM
GENERAL SAFETY
ALWAYS
keep the operator’s manual nearby for reference. Reread the manual periodically.
ALWAYS
keep all bystanders and pets a minimum of 10 feet away from your work area when operating this log splitter.
Only the operator is to be near the log splitter during use.
NEVER
allow adults lacking proper instructions and understanding to operate this log splitter.
NEVER
actuate the control until all people are clear of the work area.
NEVER
wear loose clothing or jewelry that can be caught by moving parts of the log splitter. Keep clothing and hair away
from all moving parts when operating this log splitter.
NEVER
operate the log splitter when under the influence of alcohol, drugs or medication or when otherwise not alert
enough to operate dangerous machinery.
PREPARATION OF THE LOG
Both ends of the log should be cut as square as possible to help prevent the log from riding out of the splitter during
operation. Do not split logs greater than 25 inches in length.
WORK AREA
NEVER
operate the log splitter on slippery, wet, muddy or icy ground.
NEVER
operate the log splitter in an enclosed area. Exhaust fumes contain carbon monoxide which can be deadly when
inhaled.
ONLY
operate the log splitter on level ground. Operating on a slope could cause the log splitter to roll over or logs to fall
off.
ONLY
operate the log splitter in daylight or under good artificial light.
ALWAYS
keep the work area clean. Remove split wood around the log splitter immediately so that you don’t stumble
over it.
