2. Binding the quad to a radio
The quad comes with a DSM2/DSMX compatible
satellite receiver. Please make sure your radio
system is DSM2/DSMX compatible. Otherwise you
may need to change the receiver of the quad, and
follow the installation instructions of your radio
system and Naze Rev6 flight controller.
The satellite has a binding button on the side.
Follow the following steps to finish binding.
1
.
Radio settings
DO NOT have propellers installed during setting procedures.
Unexpected startup may cause serious damages or injury.
The radio should set to
airplane mode.
5. Fight mode settings
In the mode tab, setup Aux1 switch for flight mode selection. Angle mode
is set in the factory as default and is recommended to beginners for its
stabilization function. Aux2 switch is set in factory to turn on/off beeper.
WARNING
!
2000
Roll
2000
Pitch
2000
Yaw
2000
Throttle
999
Roll
999
Pitch
999
Yaw
999
Throttle
15
00
Roll
15
00
Pitch
15
00
Yaw
15
00
Throttle
Set the middle point to 1500
Set the minimum range smaller than 1100
Set the maximum range bigger than 1900
Binding & Settings
Binding button
Sideview of
satellite receiver
Press and hold binding button
Power up the quad until satellite flashes rapidly
Release binding button.
LED stays on in DSMX mode.
LED flashes slowly in DSM2 mode.
3. Install Cleanflight configurator in your PC.
Go to Google Chrome web store and search the key word
“cleanflight” to install the software in Chrome. This is the
software to configure flight controller and your radio so that it
can start and control the quad properly.
The quad itself has been programmed in the factory and is
not necessary to make changes of the parameters for
beginners.
Online Video Instructions
Have trouble in binding and
settings? We have online video
tutorials. Scan barcode on the
right or search “Spedix S250
Pro Setup” on YouTube to
watch video instructions.
4. Cleanflight and receiver settings
