0192445 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2021 Spectrum Industries Inc., All rights reserved.
Care should be taken when moving the
desk / table on casters to prevent tipping or
shifting of the CPU tower(s) during transit.
Sling bracket
3. Install straps
3. Install straps
1. Thread each strap through the slots in the sling bracket and
base as shown in
Figure 3
with the tails hanging down.
2. Thread each strap through the buckles as shown.
3. Place the 3/4” bumper between the leg and CPU sling.
Figure 3
Strap / buckle
assembly
Buckle
Bumper
Sling base
CPU tower
1. Slide the base to the widest position and carefully place the CPU
tower into the sling.
Figure 4.
2. Slide the base tight against the tower and tighten the two wing nuts.
3. Position both buckles at the same height.
4. Tighten the straps by pulling the tails down until the CPU tower and
base are level and secure.
4. Install CPU tower
4. Install CPU tower
Figure 4
Tails
1/4-20 Wing nut
(2 required)
Sling base
2
1
3
1
2
CPU Sling
4
Nylon straps
Nylon straps
