Drum Set Assembly Instructions
2
Bass Drum Head Assembly
1.
Place bass drum head with logo on front of
bass drum head.
2.
Place one of the bass drum hoops onto drum
head.
3.
Insert long tension rod
(C)
/ washer
(A)
/bass
drum claw hook assembly
(D)
into bass
drum lug. Make sure claw hook is secure on
the bass drum hoop. Tighten with your
fingers.
4.
Repeat this for all the lugs on one side of the
drum.
5.
After all tension rods on one side are finger
tight, use the drum key
(E)
to tighten the #1
tension rod 3 turns. Follow these steps for
tension rods #2 through #6 in a criss cross
pattern as shown. Repeat this pattern,
tightening each tension rod one half turn,
until the drum head is taut and wrinkle free.
6.
Repeat for the clear batter head on the
opposite side of the drum.
Bass Drum Leg Assembly (Spurs)
1
. Insert both legs through the assemblies on the
bottom side of the bass drum and tighten screw
with drum key
(E)
.
2. Adjust the angle to ensure the bass drum
sits evenly on the floor when positioned.
Mounted Tom Head Assembly
1. Place 2 ply batter head on tom shell. The
batter drum head goes on the top.
2. Install tom drum hoop.
3. Insert short tension rods
(B)
with washers
(A)
through holes in drum hoop and tighten to finger
tight.
4. Using drum key
(E)
, gradually tighten each
tension rod screw in equal amounts in a criss-
cross pattern until head is taut and wrinkle free.
5. Repeat for bottom resonant drum head.
