043548R8 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
3. Attach slide guard
1. Flip the desk right-side up.
2. Slide the keyboard assembly into the slide.
Figure 3A
.
3. Using (2) #8 x 5/8” PHSM screws, attach the slide guard to the front
of the slide.
Figure 3B
.
Figure 3A
#8 x 5/8” PHSM
(2 required)
Slide guard
2. Attach slide to desk
1. Flip the worksurface / desk upside-down onto a non-abrasive surface.
2. Locate the slide perpendicular and about 1” from the edge of the
worksurface. The slide should not be mounted closer than 8” to the
nearest leg.
Note: The nylon spacers and longer screws are used between the slide
and worksurface only on worksurfaces with a protruding support bar.
Figure 2A
Attach 1”
from edge
Slide
Spacer
block
Underside of
worksurface
#8 x 1-3/4” PHSM
Nylon
spacer
Support bar
Figure 2B
Figure 3B
Keyboard
assembly
Rubber
Bumper
Slide under
worksurface
Installation on desks with support bar
Typical installation
3. Attach the slide using (8) #8 x 5/8” PHSM screws and tighten securely.
Figure 2A
.
4. Attach the rubber bumper toward the back of the slide using the
middle hole.
#8 x 5/8” PHSM
Slide
Attach 1”
from edge
Underside of
worksurface
3. Place the spacer block and (5) nylon spacers under the tray as
shown
Figure 2B
.
4. Attach the slide, spacer block, and nylon spacers using (6) #8 x
1-3/4” PHSM screws and tighten securely.
5. Attach the rubber bumper toward the back of the slide using the middle hole.
Rubber
bumper
