End-Support Leg Assembly
1. Attach the side panel to the leg frame as shown with (6) 8-32 x 1/2” PH thread-cutting screws and tighten securely.
Figure 4A
.
Note: The 4” grommets will be at the rear of the console.
2. Install the (2) glides onto the bottom of the leg. (The glides can be adjusted later to level the console if necessary.)
3.
Align the assembled end-support leg and wall filler panel mounting holes.
Figure 4B
.
Be sure the wall filler panel overlaps the end-support leg as shown
.
4. Attach with (4) 1/4-20 x 15mm JC bolts.
5. Worksurface attaches to the end-support leg with (2) 1/4-20 x 40mm JC bolts.
Equipment Rack-to-Equipment Rack Connection
1. Place the two equipment racks together as shown.
Figure 5
.
2.
Install (2) 1/4-20 x 90mm JC bolts and (2) 1/4-20 flanged locknuts.
3. Do not over-tighten fasteners.
0108630R11 Page 6 of 10
Figure 5
1/4-20 x 90mm
JC bolt
1/4-20 x 90mm JC bolt
1/4-20 flanged locknut
1/4-20 flanged locknut
Figure 4A
Note:
End-support legs are used only
at the end of a worksurface (not on a
seam between two worksurfaces).
Figure 4B
1/4-20 x 15mm
JC bolt
(4 required per
connection)
Wall filler
panel
Flush side of panel in end-
support leg facing outward. 4”
grommets toward rear of console.
Open area under
worksurface
Assembled end-
support leg
Glide
8-32 x 1/2” PH
thread-cutting screw
(6 required)
Glide
Be sure the wall filler
panel overlaps the
end-support leg here.
Leg frame
4” Grommet
Side panel setup for
right-side installation
on console (this side
faces
inside
console,
4”
grommets toward rear)