Figure 3
#8 x 5/8" PHSM
(3) req'd
Attaching the Slide Guard
3.
A. Slide the bracket with keyboard tray into the slide.
B. Using (3) #8 x 5/8" PHSM screws, attach the slide guard to the front of the slide.
Figure3
.
Slide Guard
A Flip the
orks rface/desk pside do n onto a non abrasi e s rface
Attaching the Slide to desks with a Support Bar
4.
A. Flip the worksurface/desk upside-down onto a non-abrasive surface.
B. Locate the slide perpendicular and about 1" from the front edge of the worksurface.
The slide should not be mounted closer than 8" to the nearest leg.
C. Place the spacer block and (5) spacers under the tray as shown in
Figure 4
.
D. Attach the slide, block and spacers using (6) #8 x 1-3/4" PHSM screws and tighten securely.
E. Attach the rubber bumper toward the back of the slide in the middle hole.
Attaching the Slide Guard
5.
A. Slide the bracket with keyboard tray into the slide.
B. Using (2) #8 x 5/8" PHSM screws, and (1) #8 x 1-3/4" PHSM screw, attach the slide guard to the front of the slide.
Figure 5
.
Slide Guard
Slide
#8 x 5/8" PHSM
(2) Req'd)
#8 x 1-3/4" PHSM
Figure 5
Figure 4
Spacer Block
Underside of
worksurface
Plastic Spacers
(5) Req'd
Slide
Rubber
Bumper
#8 x 1-3/4" PHSM
(6) Req'd
043548XR6 Page 2 of 2
