0115348R3 Page 5 of 9
1. To remove the insert panel, remove the (2) 1/4-20 x 35mm JC bolts with a 4mm hex
wrench and lift out the panel.
Figure 4A
.
2. To make cutouts in insert panel (optional):
3. Install controller(s) / electronics into panel.
4. Re-install the overbridge panel and secure with (2) 1/4-20 x 35mm JC bolts.
Note: The insert panel shown
(shaded)
is not included with the lectern or over-
bridge. This option needs to be ordered separately to complete the overbridge.
Figure 4A
1/4-20 x 35mm
JC bolt
Overbridge panel
1/4-20 x 35mm
JC bolt
A. Identify all location(s) and sizes for controller(s) or electronics while making sure
all devices fit within the maximum cutout space available in the overbridge panel.
See
Figure 4B-C
.
B. Locate and mark the exact cutout area(s) on the panel.
Note: Using masking
tape on cut lines will minimize laminate chipping while cutting.
C. Carefully make the cutout(s) in the overbridge panel using a jigsaw or router.
Overbridge insert panel (overbridge lecterns only)
Tools Required
4mm Hex
wrench
Jigsaw or Router
Drill
Pencil
Masking
tape
Drill bit
Measuring
device
