Assembly / Setup - Table with Post Legs
0118729 Page 5 of 8
Post leg
Worksurface
1. Attach Post legs to worksurface
1.
Place the worksurface upside-down (laminate side-down) onto a flat,
non-abrasive surface like another table.
Figure 2A
.
2. Attach each post leg as shown with (8) 1/4-20 x 5/8” PHM screws.
3. Install the four glides.
Phillips
screwdriver
Tools Required
Cordless drill
with Phillips driver
(best)
or
2. Attach cord channel to worksurface
1. Attach the left and right cord channels to the worksurface as shown
with 1/4-20 x 5/8” PHM screws.
Figure 2B
.
2. Install the end cap with (2) 1/4-20 x 5/8” PHMS, and (2) 8-32 x 1/2”
PH thread-cutting screws and tighten securely.
Glide
Cord Channel
(left and right)
(2) 8-32 x 1/2”
PH thread-cutting
screws
End cap
Figure 2A
Figure 2B
1/4-20 x 5/8” PHMS
(8 per)
(2) 1/4-20 x
5/8” PHMS
Phillips
screwdriver
Tools Required
Cordless drill
with Phillips driver
(best)
or
