0114813R2 Page 3 of 7
Figure 1B
The locker back panel has four 3/8” holes located 16” on-center
to match most stud-wall applications. Fasteners are not included.
(Cords from 16-outlet power units will route through bottom panel.)
1. Choose fasteners appropriate to the wall you will be anchoring to.
2.
Determine the preferred wall location and height from floor.
3. Measure and mark the (4) hole locations on the wall.
Figure 1B
. Be sure fasteners will
be anchored securely to studs or other solid portion of the wall.
4.
At the marked wall locations, drill holes appropriate to the chosen fastener type and size.
5. Support the locker (this may take 2-3 people), align the mounting holes, install fasteners,
and tighten to secure the locker to the wall.
Figure 1C
.
Four 3/8” holes are provided on the bottom panel to anchor the locker
to a worksurface for increased security. Fasteners are not included.
(Cords from 16-outlet power units will route through side panel).
1.
Set the locker into its final position. (If attaching to a table or worksurface,
be sure it is stable and sturdy enough to fully support the unit.)
2. Choose fasteners appropriate to the surface you will be attaching to. The
(4) mounting holes in the bottom panel are 3/8” dia.
Figure 1A
.
3. Mark the (4) hole locations through bottom panel.
4. At the marked locations, drill holes in the worksurface appropriate to the
chosen fastener type and size.
5. Install fasteners and tighten securely.
A. Worksurface anchoring
B. Wall-mounting
Figure 1A
WARNING
It is the customers responsibility to use appropri-
ate and adequate wall fasteners when attaching
the IT32 Tablet Locker to a wall. Nominal weight
of an empty IT32 is 76 lbs. Total loaded weight
will vary with quantity & types of tablets used.
(4) 3/8” holes
on back panel
Figure 1C
fasteners by
customer
3/8” holes for customer-
supplied fasteners
3/8” holes for
customer-supplied
fasteners
Assembly / Setup
IT32 tablet locker security
