3. Attach table to lectern
0119685 Page 4 of 4
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2015 Spectrum Industries Inc., All rights reserved.
1. If your Inspiration lectern is the mobile version, lock all four casters.
2. Set the edge of the assembled table onto the previously installed unit-to-unit bracket.
Figure 3A
.
3.
Align the bracket and worksurface mounting holes and attach with (3) 1/4-20 x 5/8” PHM screws (finger-tight only).
4. Align the modesty panel and lectern side panel mounting holes and attach with (3) 8-32 x 3/8” PHM screws.
5. Make sure the table is level side-to-side, and front-to-back, then tighten all screws securely-including the unit-to-unit bracket screws.
Figure 3A
Figure 3B
Modesty
Panel
Worksurface
1/4-20 x 5/8”
PHM screws
(3 required)
#8-32 x 3/8”
PHM screws
(3 required)
Lectern
Side Panel
Unit-to-unit
Bracket
with slots
Note: The side table with casters is only designed for
short distance mobility and repositioning within a room.
Frequently moving the unit long distances or over uneven
thresholds is not recommended. Do not lift up or pull the
table-move the table and lectern together.
Assembled
Table
Note: The table worksurface should
be parallel with the lectern work-
surface. The Unit-to-unit bracket
has slots that allow slight vertical
adjustment with the fasteners that
attach it to the side of the lectern. If
adjustment is necessary, loosen the
fasteners attaching the table to the
lectern, reposition the unit-to-unit
bracket and table, then retighten.
