4. Cord Management
1. With the back panel removed, connect the necessary monitor, keyboard, and mouse cords above the
worksurface.
Figure 4A
.
2. Position the keyboard as shown approximately 6” from the front edge of the worksurface with the mouse on the
opposite side as shown. This will provide enough slack in the cords during normal use and provide for left and
right mouse locations.
3. Use the tray slots to secure excess cord.
4. The wire loom keeps power and Ethernet cords together and routes them while the monitor is being raised and
lowered. Using a flat head screwdriver, pry open each loom clip to release the wire loom.
Figure 4B & 4C
.
0110657R5 Page 6 of 11
Figure 4C
Figure 4B
Figure 4A
iMac
®
or all-in-one
monitor
storage tray
wire loom &
clip
use slots to weave and
secure excess cord
flat head
screwdriver
Tools
Required
