057859R6 Page 1 of 4
Assembly Instructions
Important
Before you begin, please make sure all parts and proper quantities
are included. Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regarding damage, to
purchase parts or accessories, or if you have any questions, please
contact us at:
www.spectrumfurniture.com
715-723-6750, 800-235-1262
Thank you for purchasing Spectrum products!
(10) 1/4-20 x 5/8” PHMS
026064 (black)
043493 (putty)
1. Attach legs to worksurface
1. Place worksurface face down onto a non-abrasive surface.
2. Align the legs with the mounting holes, and install 1/4-20 x 1-3/4” PHM
screws into the legs as shown.
Figure 1A
.
3. Install 1/4-20 x 1-3/4” PHM screws into the legs as shown, but do not
tighten the screws completely yet.
Figure 1A
(1) 057922
chair rail bracket #1
(3) 043771
1/4-20 x 2” FHMS
(4) 041289
1/4-20 x 1-3/4” PHMS
(1) 025069
glide wrench
For 60” & 72” desks only:
Orient and attach the chair rail brackets to the center of the work-
surface as shown in
Figure 1B
with (2) 1/4-20 x 5/8” PHM screws.
The side of the leg without
the end cap should be
facing the flip-top on the
worksurface
Phillips
screwdriver
Tools Required
Evolution Desk 24”D
(1) 057890
chair rail bracket #2
(for 60”, and 72” desks only)
glide wrench
Figure 1B
flip-top
worksurface
1/4-20 x 1-3/4”
PHMS
(4 required)
flip-top
chair rail bracket #2
chair rail bracket #1
1/4-20 x 5/8” PHMS
(2 required)
worksurface
(4) 025068
5/16-18 x 1” glide
(2) 052463
unit-to-unit bracket
(2) 026011
1/4-20 x 2” FHMS
The legs should be
attached with the side
panels flush with the legs.
(2) leg
(1) worksurface
(1) chair rail
(1) cord channel /
modesty panel
38912ADJ - 36”W
38915ADJ - 60”W
38916ADJ - 72”W
38912 - 36”W
38915 - 60”W
38916 - 72”W
