Modesty panel /
cord channel
1/4-20 x 5/8” PHMS
(4 required)
Glides
(4 required)
Lower section
Up to 8” of
adjustment
Up to 8” of
adjustment
Adjustment
screws
8”
24”
32”
052519R6 Page 3 of 5
1. Orient the modesty panel/cord channel as shown and attach
to the legs with (4) 1/4-20 x 5/8” PHM screws.
Figure 3.1
.
2. Install the (4) glides to the bottom of the legs. The glides can
be adjusted later to keep the desk level on uneven surfaces.
3. Tighten ALL screws.
Note: If you are assembling a 60, or 72” desk, slide the
cord channel over the chair rail bracket. The bracket will
support the inside of the cord channel.
Figure 3.2.
Figure 3.2
Figure 3.1
Chair rail bracket
Cord
channel
Install cord channel / modesty panel and glides
3
Figure 3.3
Figure 3.4
Leg adjustment
The worksurface height can be adjusted from 24”H - 32”H in 1” increments.
Figure 3.3
. Adjustment is easier when the desk is upside-down.
1. To adjust the legs, remove the (4) pre-installed adjustment screws.
(Fully-support the lower section of the leg while removing).
Figure 3.4
.
2. Choose a height and align the corresponding set of leg holes.
3. Install the (4) previously removed screws in the new holes and tighten securely.
4. Repeat this procedure on the second leg. Make sure to use the same set of
holes as used on the first leg.
