Metal side panel fasteners
(4) 8-32 x 1/2” PH Thread-cutting screws
Shelf bracket
Laminate side panel
Installation video available
See www.spectrumfurniture.com
11/32
”
Laminate Side Panel
(interior view)
Upper shelf
position holes
Lower shelf
position holes
0191814R2 Page 2 of 4
Link Lectern (55115) installation:
Link Lectern (55115) installation:
Laminate side panels
Metal side panels
2” Grommet
Flip-up shelf
(2) Folding
shelf bracket
8-32 Keps nut
(use 11/32” wrench)
3/16” Flat steel
washer
8-32 x 1” PHMS in
3/16” drilled hole
from Figure 1.2
8-32 x 1/2” PH
thread-cutting screws
(Install lower 4 first)
Before you begin determine:
• The side of the lectern the shelf will be installed (left or right side)
• The shelf position: (Upper or lower)
• Type of side panels your lectern has (metal or laminate)
Attaching to laminate side panels:
1. Open the lectern door and remove the rack
cube (if equipped).
2. From inside the lectern, use a drill with a 3/16”
drill bit and slowly drill out the corresponding
pre-drilled pilot holes located on the laminate
side panel. Masking tape can be used on the
exterior to minimize chip-out.
Drill with
3/16” drill bit
3/16
”
1. Extend and lock each folding shelf bracket into the horizontal position.
2. Select the fasteners needed (Metal or laminate side panels)
3. Install the (4) lower screws into the side panel at the preferred
height leaving about 1/4” of threads exposed.
4. Set the shelf assembly onto the (4) lower screws using the notched
brackets.
5. Secure the shelf assembly by installing the (4) upper screws.
6. Tighten all 8 screws securely.
7. Install 2” grommet in shelf.
Laminate side panel fasteners
(4) 8-32 x 1” PHMS
(4) 3/16” Flat steel washers
(4) 8-32 Keps nuts
