Assembly Instructions
Worksurface
or floor
Wall
0190201R1 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Stacking Kit
for Connect10 Locker
55491
1.
With the first locker on a stable permanent worksurface or floor,
carefully stack the second locker on top. This may require two people.
2.
Place the rear stacking bracket between the two lockers as shown.
Figure 1
. Be sure the two bracket tabs are hooked into the upper
vent slot on the lower locker.
3. Align the bracket / locker mounting holes and threaded studs.
Lift the rear of the upper locker slightly to align the bracket holes
around the glides.
4.
Install (2) 8-32 Keps nuts and (4) 8-32 x 1-1/2” PH Thread-cutting
screws, but do not tighten completely.
WARNING
•
This stacking kit is
not
designed to hang locker from a wall.
•
One 55491 kit will stack one locker onto another that sits on a
worksurface or floor (one kit is required for each additional level).
•
Max recommended stack height: 2 units.
• A stack of 2 or more
must be secured to floor or wall
.
(4) 0100167
8-32 x 1-1/2” PH
Thread-cutting
screw
(2) 021588
8-32 Keps nut
(1) 0132020
Rear Stacking Bracket
Ratcheting
wrench with
5/16” socket
Tools Required
Figure 1
1. Install rear stacking bracket
(2) 052605
1/4-20 x 15mm
JC bolt
(1) 0132015
Left stacking
bracket
(1) 0132018
Right stacking
bracket
Phillips
screwdriver
4mm Hex
wrench
(included)
Rear Stacking Bracket
(2) 8-32 Keps nut
(4) 8-32 x 1-1/2”
PH Thread-
cutting screw
Lower Connect10 Locker
Upper Connect10 Locker
(1) 025039
4mm Hex
wrench
