AppBox D21 System User’s Guide 10
AppBox
2.4 Installation of Atmel-ICE emulator
Listed below are the steps to install Atmel-ICE emulator:
1. Remove
ALL
power to the AppBox D21 enclosure
2. Remove all interface connections attached to the AppIO Modules
3. Remove the USB/RS-485 connections to the processor Module
4. Turn the AppBox over and remove the 2 screws from the bottom of the enclosure as shown
below
5. Turn the AppBox back over (label showing) and lift the top off the enclosure being careful not to
lose the knockout panels
6. Plug the emulator end of the ribbon cable into the “SAM” Port on the emulator
7. Plug in the Atmel-ICE debug into connector J6 on the AppBox D21 CPU board. Visually inspect
the connection to insure all the board pins are in the female cable connector.
8. Re-attach the USB/RS-485 connections to the processor board
9. Re-attach all interface connections to the AppIO Modules
10. Apply power to the AppBox D21
11. Start debug session on the host computer
Screws
AppBox Bottom Screw Locations
D21 CPU Board
Atmel-ICE Attached to AppBox D21 CPU Board
Atmel-ICE
J6 Connector
RED
Wire
SAM Port
