Spectrum Controls Micro800 2085sc-IF16C, Руководство пользователя

Страница: 27 / 60

Chapter 3: Configuring the 2085sc-IF16 Using CCW 3-1
User’s Manual Pub. 0300306-02 Rev. B
Chapter 3
Configuring the 2085sc-IF16
Using CCW
This chapter covers the following subjects:
• How to use Connected Components Workbench (CCW) and optionally
ModuleConfigConverter.exe software to configure the Module.
• Analog Data and Status settings.
•
Data Links settings.
•
Setting configuration parameters and associated values.
Section 3.1
Introduction
You use CCW software (v 9.00.00 and above) to configure the 2085sc-IF16
Expansion I/O Module. Your controller firmware must be at v. 9.011 and above
as well. You then send the configuration setup to the module. Starting from CCW
version 11.00.00 and later, the software provides a module-specific Add-On
Profile (AOP) to configure the module. The process for manually importing AOP
to CCW is no longer required.
The Micro850/870 Controller (Bus master) subsystem is located at the left end of
the bus. This subsystem is comprised of:
•
Micro850/870 Controller.
•
2085 Expansion I/O Modules.
• 2085-ECR Bus Terminator.
Optional:
•
2080-PS120-240VAC Power Supply (separate module or built-in the
main controller).
• 2080 Plug-in Modules.
• 2085-EP24VDC Expansion Power Supply for Micro870 Controller with
more than four 2085 Expansion I/O Modules installed.