Spectrum Controls 2085-IF4XOF4-SC, Руководство пользователя

Страница: 12 / 68

1-4 Chapter 1, Module Overview
User’s Manual Pub. 0300307-01 Rev. A
Parameter Specification
Pollution Level Meets Pollution Degree 2 requirements 1 .
ESD Meets CE requirements for operating ESD category B at 6 kV
indirect (coupling plate).
Radiated Immunity
10 V/m with 1 kHz sine-wave 80% AM from 80…2000 MHz
10 V/m with 200 Hz square wave 50% Pulse 100% AM at 900
MHz
10 V/m with 200 Hz square wave 50% Pulse 100% AM at 1890
MHz
10 V/m with 1 kHz sine-wave 80% AM from 1000…2000 MHz
10 V/m with 1 kHz sine-wave 80% AM from 2000…2700 MHz
Outputs per module
4 current/voltage output channels
Inputs per module
4 current/voltage input channels
Power Consumption Maximum 110 mA at 5 V (4.5 V to 5.5 V) from backplane; (0.55
W)
Maximum 125 mA at 24 V (19.9 V to 26.4 V) from backplane
Nominal 24V; (3 W)
Power Dissipation (within
module) (current mode)
Less than 4 W at 50 Ohm resistance load on all output channels
Less than 3.6 W at 250 Ohm resistance load on all output
channels
Less than 3.2 W at 500 Ohm resistance load on all output
channels
Peak Inrush Current Less than 150 mA for +5 V from backplane and rail
Less than 500 mA for +24 V from backplane
Module Scan Time for all analog
channels
Less than 3 seconds. For the normal case, no communication
error occurs between channels and backplane.
Isolation
Between channels and backplane
50 VAC working Reinforced isolation tested at 2 kVDC for 1
minute.
Between Channels and chassis
ground
50 VAC working Reinforced isolation tested at 2 kVDC for 1
minute.
Wire size #16 to #28 AWG
Wire Strip Length 0.375 in.
Recommended Tightening
Torque:
0.25 N-m (2.2 lb-in)
RoHS
Meets European RoHS component standards (January 2015 and
earlier).
1
Pollution Degree 2 is an environment where, normally, only non-conductive pollution occurs except that
occasionally a temporary conductivity caused by condensation is expected.