Spectro-UV Spectroline Q Series, Руководство оператора

Страница: 3 / 8

3
4. The tubes should become energized and emit a steady glow of light. The light
may initially flicker, especially if the lamp is cold, but should stabilize after a
few seconds.
5. To turn the lamp off, depress the red POWER OFF switch(es).
INSTALLING ACCESSORIES
1. To attach a lamp to the SQ-130 pedestal stand, place the stand on a level
surface. Slide the open end of the lamp handle onto the stand receptacle. Do
not force the handle onto the stand or it will lodge too tightly and be difficult
to remove. Adjust the lamp vertically to achieve the most comfortable viewing
position.
2. To mount a lamp equipped with a flexible arm, attach the mounting bracket
provided to the bench, table or wall away from obstructions to allow for mobility
of the lamp. Insert the arm into the bracket and adjust the lamp horizontally
and vertically as desired.
OPERATOR SERVICING
The following servicing instructions are intended for limited maintenance of
the lamp. Do not perform any servicing other than that contained in these
instructions. Return the lamp to the factory for other maintenance not covered in
this section.
HOUSING AND MAGNIFIER LENS MAINTENANCE
The polycarbonate lamp housing protects the internal parts. Immediately clean
spills from the housing and magnifier lens with water and a mild detergent
and wipe dry with a soft cloth. Do not allow any liquids to leak into electrical
components. Periodically clean the lens with a glass cleaner and a soft cloth.
TUBE AND REFLECTOR MAINTENANCE
T
o clean the tubes and/or reflector, see the ‘’TUBE REPLACEMENT’’ section.
Using a soft cloth, the reflector may be cleaned with a glass cleaner, while the
tubes may be cleaned with a mild detergent solution. Wipe dry with a soft cloth.
SHORT WAVE FILTER MAINTENANCE
To clean the filter, remove the two screws holding the filter assembly and slide it
off the open end of the lamp housing. Clean with a soft cloth and a glass cleaner.
TUBE REPLACEMENT
When replacing a tube, unplug the lamp from its power source before proceeding.
1. Lay the lamp housing on a flat, level surface with the tubes facing up. For
lamps without a filter assembly, proceed to step #3.
2. Remove the two screws holding the filter assembly and slide it off the open
end of the lamp housing and set it aside.
WARNING
To avoid the risk of electrical shock, always unplug the lamp from its
power source before cleaning or servicing.