2
WARNING
UV light emitted from this product. Avoid eye and skin exposure to
unshielded products.
FOR PROFESSIONAL EXAMINATION USE ONLY
OPERATION
1. Connect the plug to a power outlet that complies with the electrical
requirements specified on the lamp’s label. The E-Series lamps are
available in 120V/60Hz, 230V/50Hz, 240V/50Hz or 100V/50-60Hz versions.
2. The power supply cord is the disconnect for this unit.
3. To turn on the 120V and 100V models, press and hold the dimple on the
rocker switch(es) for approximately 5 seconds to power the tube(s). To power
the 230V/FE and FBE and 240V/FA models, press the rocker switch to the
ON (I) position. The 230V models designed to produce two wavelengths have
a 3-position power switch. The tube(s) should become energized and emit
a steady light. The light may initially flicker, especially if the lamp is cold, but
should stabilize after a few seconds.
4. To turn off the 120V and 100V models, press down on the opposite side
of the switch. Press the rocker switch to the OFF (O) position on the 230V
and 240V models.
IMPORTANT SAFETY INSTRUCTIONS (Read all instructions prior to lamp usage)
•
Never use this lamp in any manner not specified in these instructions.
•
Do not use if a tube, cord or plug is not fully serviceable.
•
We recommend using Spectroline UV-absorbing protective eye and face wear
(i.e., UVS-30 spectacles, UVG-50 goggles or UVF-80 face shield).
•
FOR LABORATORY USE ONLY
