FILTER REPLACEMENT
To replace the filter assembly in lamps equipped with filters:
1. Disconnect the lamp from its power source.
2. Lay the lamp housing on a flat, level surface.
3. Remove the two screws that hold the endcap opposite the power cord.
4. Slide the filter assembly off the lamp housing’s open end and set it aside.
5. Install the new filter assembly by reversing the above procedure.
TUBE REPLACEMENT
If the lamp fails to operate properly, the tube(s) may need to be changed.
1. Disconnect the lamp from its power source.
2. Lay the lamp housing on a flat, level surface.
3. If the lamp has a filter, remove the filter assembly by following the steps outlined in the FILTER REPLACEMENT section.
4. Grasp the tube by the metal bases at each end. Applying even pressure, gently rotate the tube one-quarter of a turn until it
loosens.
5. Install the new tube and replace the filter assembly by reversing the above procedure. If the lamp still fails to work properly, make
sure the two pins at each end of the tube are properly connected with the two copper contacts in each socket.
MAINTENANCE OF THE UNIT
Do not allow liquids to leak into the electrical components.
Immediately clean liquid spills from the housing with a damp, soft
cloth and a mild detergent. Wipe dry. To clean the filter (if the lamp is equipped with one) or the reflector, use a soft cloth and a glass
cleaner. Wipe dry. To clean the tube(s), remove them according to the instructions in the TUBE REPLACEMENT section. Clean the
tube(s) with a soft cloth and mild detergent solution. Wipe dry.
WARRANTY
The warranty policy for the E/12-Series lamps is provided on the Certificate of Limited Warranty enclosed separately with each unit.
NOTE
: For assistance of any kind, contact the Customer Service Department at Spectro-UV. Call toll-free 1-866-230-7305. Give full
details of the difficulty and include the model and serial numbers of the unit and the date of purchase. If return of the unit or
any components to the factory is deemed necessary, shipping instructions will be provided. If an
estimate of charges for nonwarranty work or other service work is required, a quote will be furnished upon evaluation of the unit.
Out-of-warranty service work will not be performed without customer approval.
9/20 A98139-6
PRINTED IN U.S.A.
LAMP CONTAINS MERCURY
Manage in Accord with Disposal Laws
See: www.lamprecycle.org
ORDERING INFORMATION
Description
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Part No.
Battery Pack, Complete with 12V, 7 Ahr, Rechargeable Battery with
Female Cigarette Lighter Receptacle, RB-12S Battery Charger,
Circuit-Protector 2A Fuse and Nylon Carrying Case . . . . . . . . . . . . . . . . BP-12A
Battery Pack, Same as Above, but with RB-12S/F Charger . . . . . . . . . . . BP-12A/F
Adapter with 10-Foot AC Cord—for 4- and 5-Watt Lamps (120 Volt) . . . . . AP-12/4
Adapter with 10-Foot AC Cord—for 6- and 8-Watt Lamps (120 Volt) . . . . AP-12/6
Battery Adapter with Alligator Clips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .AA-12
Battery Adapter with Male Cigarette Lighter Plug . . . . . . . . . . . . . . . . . . . . . . AL-12
Rechargeable Battery,12V, 7 AHr . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9B65
Battery Charger, Manual (120V/60Hz) . . . . . . . . . . . . . . . . . . . . . . . . . . . . RB-12S
Battery Charger, Manual (230V/50Hz) . . . . . . . . . . . . . . . . . . . . . . . . . . .RB-12S/F
Lamp Carrying Handle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CH-180
Lamp Stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .SE-140
Spectacles, UV-Absorbing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UVS-30
Goggles, UV-Absorbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UVG-50
Face Shield, UV-Absorbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UVF-80
