Chapter 6. Using the Serial Port Interface
56
Password Configuration
As shipped, the serial port configuration menu is
not
password protected. To prevent
unauthorized changing of library configuration settings, you can enable a password.
1.
Select
1
from the Configuration Menu.
2.
The Password Configuration Menu is displayed (Figure 6-10).
[1] Set Password:
Select to set or change the password. If changing the password, you will
be prompted to enter your password, then to re-enter it. Once it is set, it will be
required to make any subsequent configuration changes.
Note:
This password is also used to validate firmware updates using FTP.
[2] Disable Password:
Select to disable your password.
[?] Help:
Displays help for this menu.
[ESC] Return to previous menu:
Returns you to the main menu.
3.
Select
1
to set a configuration password.
4.
Press
Esc
to return to the Configuration Menu.
There will be an asterisk (
*
) next to the menu option, indicating that an unsaved
change has been made.
5.
Select
9
from the Configuration Menu to save the changes.
6.
Select
y
when prompted to reboot.
Note:
You must reboot the library in order for the username and
password changes to take effect.
Figure 6-10
The Password Configuration Menu.
