Connect the audio (red and white) cables to the AUDIO INPUT R and L
jacks on the back of the monitor and to the Audio Output jacks on the
DVR.
Viewing the Picture From the Connected Device
1. Plug in the monitor and the device if they aren't already plugged in.
2. Turn on the monitor and the device you want to view, for example a
camera.
3. Repeatedly press the SOURCE button until you see AV
displayed at
the top of the monitor's screen.
Note:
If the picture from the DVR is blue and your device is connected to
the VIDEO Input, you might be tuned to the wrong input. Make sure you
press Source until you see AV displayed at the top of the monitor's screen.
3. Connecting the Monitor Cables to your Computer
Make sure all cable connections are fastened -- tighten all cable screws.
Shaking and vibration may dislodge cables that are improperly connected.
Route all wiring and cabling away from heat sources and sharp metal
edges to avoid damage.
4. Testing the Monitor
After connecting, turn on the power switch located at the rear (or side) of
the bezel. Before you test your monitor, make sure all cables are
connected properly and routed through the cable management system. Be
sure to tighten all cable screws. To test that the monitor is working properly:
1. Turn on your pc or DVR.
2. Make sure the video image is displayed. If it is not, turn on your monitor.
Ensure the LED indicator is blue
– red indicates power but no signal.
3. Make sure the video image is centered within the screen area. Use the
monitor controls to adjust the image, if necessary. Perform an Auto
Configuration first, then if you wish you can adjust the horizontal and
vertical position, contrast, and brightness to better suit your video card
and your personal preferences. Refer to Basic OSD setup for more
information on using the on-screen menu to adjust the video display.
Front Controls
(
a
) 5 Key Series
SOURCE MENU - + POWER
1. POWER:
Turn the monitor on or off.
2. SOURCE:
Press this button to switch between input modes
AV, DVI ,
and VGA
. On-screen OSD mode, press this button (move up or down)
to select a sub menu.
3. MENU
：
Press to view the On-screen OSD of the unit. Sub-menus,
features, and settings differ according to input mode on the
on-screen
display, press this button to exit from main menu, sub-menus, features
and settings.
4.
＋
and
－
:
Press
＋
button to Increase or
－
button to decrease volume
from 1-100
，
on-screen OSD ,
press
＋
or
－
to adjust the settings.
5.
Remote indicator:
red when standby mode and blue when on display.
(b)
、
Choose the input source
8
7
Controls
