Precautions
• Be sure to disconnect the unit before
installation and connection.
• The installation should be made by
qualified service personnel or system
installers.
•
Do not expose the power and
connection cables to moisture, which
may cause damage to the unit.
Connecting to the
Network
Connecting Power Source
Connecting Microphone
and Speaker Device
Connecting Alarm Device
To use a power adapter
To use PoE (Power over Ethernet)
NOTE:
NOTE:
NOTE:
ALARM IN & OUT / ALARM IN & OUT
RETURN (Sensor Input / Relay Output)
NOTE:
You can control and monitor the system via
network. With remote control (monitoring),
you can change the system configuration or
monitor the image.
Connect the IP camera to your network using
a standard RJ-45 network cable
• When the connecting Alarm and Audio,
tighten the screws
• Put your finger between the power
connector and the camera body to pull
out the connector.
Connect power, using one of the methods
listed below:
Connect a DC 12 V power source to the power
input terminal as shown below.
(recommended power adapter is DC 12 V/1.5
A or above)
Connect an ethernet cable to the LAN port on
the unit and to the PoE device. You must use
a “IEEE802.3af” standard PoE device.
Optionally connect an active speaker and/or
external microphone with a built-in amplifier.
If the camera doesn’t work properly after
connecting to the PoE device, please check if
the PoE device is supplying enough power.
• The Photo MOS Relay is rated for 100 mA
at DC 20 V or 100 mA at AC 28V.
• Grasp both ends of the 3 or 4 pin
connector plug and then sway both side
to pull it out.
Keep the microphone away from the speaker
to avoid howling.
Connect the sensor device and alarm (relay)
device to the alarm terminal. Alarm signal is
sent out at an event occurrence.
Alarm terminals are used to connect the
alarm (relay) devices such as sensors, door
switches, etc.
Connection
①
IR LED:
The sensor in the middle of IR LEDs detects
low illumination and the IR LEDs are lit at night
or under low lighting conditions.
②
Lens:
Motorized Lens is installed.
③
Bottom Base:
Fixed Base on the Wall Ceiling
④
Factory Reset Switch:
Use to return all settings to the
original factory settings.
⑤
Power:
When camera connect power supply,
LED light on
1. Screw the bottom cover to the wall or ceiling by using the mounting screws provided with the camera. Use the mounting template
provided with the camera.
2. Connect the external devices, network and power adapter.
3. Adjust the angle of the lens for the proper view angle. Refer to the View Angle section below for details.
4. Adjust the focus and zoom by using the focus and zoom lever.
5. Fix the shield case in the tilt adjustment screw.
6. If the camera is a vandal dome model, screw the dome cover to the bottom cover by using the setscrew provided with the camera. If the
camera is a plastic dome model, match the mark beside the cable access hole of the bottom cover and the side cable access hole of the dome cover,
and then turn the dome cover clockwise to lock the dome cover to the bottom cover.
7. Apply power.
WARNING: You might need to reinforce the wall or ceiling. If the wall or ceiling is not strong enough to
support the camera, the camera might fall damaging the camera or causing injuries
Part Names and Functions
Connection Guide
Connection Guide
5(6(7
32:(5
①
②
③
④
⑤
