1.
Run a CAT 5 cable to the back box lo-
cation; punch out one of the knock out
tabs to run the wire through.
NOTE:
It is
recommended the wire is run up through
the bottom knock out hole; this will give
more room for the RJ45 connector, and
will alleviate any issues of pinching the
wire during installation.
2.
Attach the Wall Dock to the Back Box
with the two mounting screws that are
provided with the wall dock.
3.
Starting from the left, angle the MODE
Free into the Wall Docking Station, then
click into place.
4.
Finished Product
LIMITED 2-YEAR WARRANTY
Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were
purchased, or to the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is
preferable to ship this product in the original shipping container to lessen the chance of transit damage. In any case, the risk or loss or damage in
transit is to be borne by the purchaser. If upon examination at the Factory or SpeakerCraft Authorized Dealer it is determined that the unit was defec-
tive in materials or workmanship at any time during this warranty period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair
or replace this product at no additional charge, except as set forth below. If this model is no longer available and can not be repaired effectively,
SpeakerCraft, at its sole option may replace the unit with a current model of equal or greater value. In some cases where a new model is substituted,
a modification to the mounting surface may be required. If mounting surface modification is required, SpeakerCraft assumes no responsibility or
liability for such modification. All replaced parts and product become the property of SpeakerCraft Inc. Products replaced or repaired under this
warranty will be returned to the original retail purchaser, within a reasonable time, freight prepaid.
This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or
shipping procedures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the product
which has not been authorized or approved by SpeakerCraft. This warranty also excludes normal cosmetic deterioration caused by environmental
conditions. This warranty will be void if the Serial number on the product has been removed, tampered with or defaced.
This warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted above, the purchaser's
sole remedy shall be repair or replacement as provided above. In no event will SpeakerCraft be liable for any incidental or consequential damages
arising out of the use or inability to use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized Dealer has been advised of the pos-
sibility of such damages, or for any claim by any other party. Some states do not allow the exclusion or limitation of consequential damages, so the
above limitation and exclusion may not apply.
All implied warranties on the product are limited to the duration of this expressed warranty. Some states do not allow limitation on the length of an
implied Warranty. If the original retail purchaser resides in such a state, this limitation does not apply.
If you have any questions regarding this or any other SpeakerCraft product, please contact your local Authorized SpeakerCraft dealer, or you may
contact SpeakerCraft toll-free at 1-800-448-0976 for immediate customer assistance. We are available to assist you every weekday, except holidays,
between the hours of 7:00 a.m. and 5:00 p.m.
LIT14420(rev2)
SPECIFICATIONS
WALL DOCK AND KEYPAD INSTALLATION
940 Columbia Avenue, Riverside, CA 92507 | USA (800) 448 0976 Fax (951) 787 8747 Interna1 951 787 0543 | www.speakercraft.com
Cut-Out Size:
W 4
7
⁄
8
” x H 4
1
⁄
8
”
(124 mm x H 105 mm)