Speck EQ16-16, Справочное руководство, Страница: 7 / 33

To avoid personal injury, do not remove the top cover from the power
supply, or the rear panel of the Model EQ16 and never operate the
external power supply without the cover properly installed. If it
becomes necessary to remove the rear panel of the EQ16 for service,
always unplug the AC power and disconnect the DC interface cable
before proceeding.
The EQ16 is available in two versions: The EQ16-16; 16 mono three
band equalizers, and the EQ16-32; 16 stereo three band equalizers. The
EQ16 may be connected virtually anywhere in the line level audio path
of professional equipment where equalization is required.
The Model EQ16 is a 3 rack space chassis that incorporates 16
independent channels of three band semi-parametric equalizers. Its
versatility and applications are limited only by your imagination. The
Model EQ16 is well suited in audio applications from professional
recording, sound contracting, public address, stage, or any application
where equalization is required.
Some of the many applications of the Model EQ16 is when interfaced to
the Speck Electronics Xtramix or any one of the many commercially
available recording mixers that lack the complete 3 sweepable bands of
the Model EQ16, or lack equalization altogether.
The Model EQ16 will accept a wide variety of signal levels. From the
wide range of levels developed from synths or samplers (typically
-20 dBu to +10 dBu) to the highest levels developed by professional
recorders (typ4 dBu to +22 dBu).
Each channel of the Model EQ16 is divided into 3 bands; the low
frequency band, mid frequency band, and high frequency band. Each
band has 2 controls; the frequency sweep control and boost/cut control.
The Model EQ16 is supplied with an external rack mount regulated
power supply. The Model EQ16-16 (16 mono channel version) is
supplied with the Model PS3-0.8 power supply. The Model EQ16-32
(16 stereo channel version) is supplied with the higher powered Model
PS3-1.5 power supply.
Both versions of the PS3 power supply include a IEC power entry
connector, a 3 conductor AC power cord, and a 6 foot DC cable. The
DC cable has a 6 pin connector at one end that plugs into the power
supply, and a 6 pin connector at the other end that plugs into the EQ16.
This cable may be secured to the rear chassis of the EQ16 for a positive
connection.
Do not remove covers or panels
General Description
3
Standard Accessories
Model PS3 power supply
Chapter 1 Introduction Section