Speck pumps Badu Eco Touch II, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 14

4
NOTE: In Canada, the pump must be located a minimum of three (3) meters (approximately ten (10) feet) from
the water (CSA C22.1).
1. It is recommended to install the controller at least ten (10) feet from the inside wall of the pool.
2. Mount the controller on a solid wall which provides a rigid and vibration-free support so that it is readily
accessible for programming.
3. Protect the controller from direct sunlight and excessive moisture. (rain, sprinklers, etc.)
4. DO NOT store or use gasoline or other lammable vapors or liquids in the vicinity of this controller. DO NOT
store pool chemicals near the controller.
5. DO NOT remove any safety alert labels such as DANGER, WARNING, or CAUTION . Keep safety labels in
good condition and replace any missing or damaged labels.
Location
3
Installation
Preparation Guide
1. Upon receipt of the controller, check the carton for damage. Open the carton and check the controller for
concealed damage, such as cracks, or dents. If damage is found, contact the shipper or distributor where the
controller was purchased.
2. Inspect the contents of the carton and verify that all parts are included (ie Controller, wall transformer, and
manual). Cable with snap-in connector is sold separately.
Dimensions
When installing and using the controller, basic safety precautions should always be followed. The wiring of the
controller should be done by a licensed electrician in accordance with local codes.
6.75"
2.0"
3.5" 3.25"
1.0"
1.625"
Installation