9
(a)
Fit the Retaining Ring onto the new Diaphragm.
(c)
Pull the Inner Extension Pipe up through the
body, positioning the tabs so that they can
be pulled through the holes in the IEP Locator.
(e)
Check that the Diaphragm is correctly located.
If it has become twisted during the installation,
simply untwist by slightly turning the
open end of the Diaphragm.
(g)
Place the Outer Extension Pipe over the
Inner Extension Pipe.
(b)
Push the Diaphragm onto the Inner Extension
Pipe.
(d)
Gently turn the Inner Extension Pipe so the
tabs are aligned with the recesses in the IEP
Locator. Release the Inner Extension Pipe.
(f)
Slide the Thrust Washer over the Inner
Extension Pipe. The flat side (widest diameter)
of the Thrust Washer should face down.
(h)
Screw the Locking Nut into place to lock
the assembly. Be careful not to over-tighten
the Locking Nut.
(i)
Check that the Outer Extension
Pipe swivels freely.
To install a new diaphragm, simply reverse the process:
