8999128: v1 03/09/2018
Page 7.2 of 7.7 pages
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
7.2
Hot points on the machine
Before performing any maintenance work, make sure parts of the machine that can get hot have been allowed to cool,
namely:
•
Gearbox (speed increaser);
•
Central gearbox (transfer);
•
Drive shafts;
•
Right- and left-hand drive belt guards;
•
Drive belts;
•
Drive pulley;
•
Rotor mounts (opposite side to drive belts).
7.3
Greasing
Only use a manual grease pump to avoid busting the seals on the bearings and pipes the grease travels through.
Use SKF LGHT3 grease or equivalent grade. Grease the points indicated below daily.
• PTO shaft, see Figure 7.1 (also see relevant manual);
• Rotor, on both sides of each of the two rollers, see Figure 7.2;
• Rear rollers, on both sides of the machine, see Figure 7.3;
• Cylinder and lift arm, on both sides of the machine, see Figure 7.4;
• Rear support wheels (optional extra), see Figure 7.5.
Figure 7.1
Figure 7.2
Figure 7.3
Figure 7.4
Figure 7.5
