Spearhead Outfront Flail 130, Руководство по эксплуатации и каталог запасных частей

Страница: 2 / 49

Spearhead Outfront Flail
2
IMPORTANT
VERIFICATION OF WARRANTY REGISTRATION
DEALER WARRANTY INFORMATION & REGISTRATION VERIFICATION
It is imperative that the selling dealer registers this machine with Spearhead Machinery Limited before delivery to the end
user
– failure to do so may affect the validity of the machine warranty.
To register machines go to the Spearhead Machinery Limited web site at
www.spearheadmachinery.com
, log onto ‘
Dealer
Inside
’ and select the ‘
Machine Registration button
’
which can be found in the Service Section of the site. Confirm to the
customer that the machine has been registered in the section below.
Should you experience any problems registering a machine in this manner please contact the Spearhead Service
Department on 01789 491867.
Registration Verification
Dealer Name:
……………………..…………………………………………………………….
Dealer Address:
…….………………………………………………………………………….
Customer Name:
……………………..…………………………………………………………
Date of Warranty Registration:
……/……/...…… Dealer Signature: ………………..……
NOTE TO CUSTOMER / OWNER
Please ensure that the above section has been completed and signed by the selling dealer to verify that your machine has
been registered with Spearhead Machinery Limited.
IMPORTANT: During the initial ‘bedding in’ period of a new machine it is the customer’s responsibility to regularly inspect all
nuts, bolts and hose connections for tightness and re-tighten if required. New hydraulic connections occasionally weep small
amounts of oil as the seals and joints settle in
– where this occurs it can be cured by re-tightening the connection –
refer to
torque settings chart below. The tasks stated above should be performed on an hourly basis during the first day of work and
at least daily thereafter as part of the machines general maintenance procedure.
CAUTION: DO NOT OVER TORQUE HYDRAULIC FITTINGS AND HOSES
TORQUE SETTINGS FOR HYDRAULIC FITTINGS
HYDRAULIC HOSE ENDS PORT ADAPTORS WITH BONDED SEALS
BSP Setting Metric BSP Setting Metric
1/4”
18 Nm 19 mm
1/4”
34 Nm 19 mm
3/8”
31 Nm 22 mm
3/8”
47 Nm 22 mm
1/2”
49 Nm 27 mm
1/2”
102 Nm 27 mm
5/8”
60 Nm 30 mm
5/8”
122 Nm 30 mm
3/4”
80 Nm 32 mm
3/4”
149 Nm 32 mm
1”
125 Nm 41 mm
1”
203 Nm 41 mm
1.1/4”
190 Nm 50 mm
1.1/4”
305 Nm 50 mm
1.1/2”
250 Nm 55 mm
1.1/2”
305 Nm 55 mm
2”
420 Nm 70 mm
2”
400 Nm 70 mm